Where is the flasher relay on a 99 Dodge Durango?

Where is the flasher relay on a 99 Dodge Durango?

combination flasher, in the junction block on the left end of the instrument panel.

Is there a turn signal relay?

The turn signal relay or the hazard lights found in all vehicles are controlled by a flasher. This flasher is commonly referred to as the relay. This also enables the flashing of the turn signal relay or the hazard light. These are the simplest components of a car both in design and operation.

How do you change a turn signal relay?

Replacing the Turn Signal Relay

1. Locate your relay cluster. You can find this in your car’s owner’s manual.
2. Locate the turn signal relay. This should also be in your owner’s manual.
3. Once you can see your relays, remove the old turn signal flasher relay and replace it with the new one.

What would make your turn signals stop working?

The usual cause of inoperative turn signals is a defective bulb or flasher unit. Prior to performing extensive diagnosis, check the vehicles fuses to ensure they are not blown. Some vehicles utilize two fuse boxes, one in the passenger compartment and another under the hood.

How do you test a turn signal relay?

How to Test a Flasher Relay

1. Access the junction box where your flasher relay is located.
2. Turn your car or truck’s ignition on.
3. Connect the clip of the test probe to any good ground.
4. Remove the relay and locate its control and power terminals.
5. Turn your multimeter on and set it to the ohms setting.

Why did my turn signals stop working?

One Side of the Turn Signal Lights Doesn’t Work. You may be dealing with bad bulbs, a bad flasher relay, a faulty turn signal switch, or a bad wire or connector between the flasher unit and the turn signal switch. First, check the bulbs to see if they are still in good shape: No darkened areas or damaged filaments.