What is the administrative distance of directly connected route?
Connected routes always take precedence over static or dynamically discovered routes because they have the administrative distance value of 0 (the lowest possible value).
What is the default administrative distance of a static route if you use an exit interface instead of a next hop address?
Static routes have a default administrative distance of 1. This route that has an administrative distance of 5 will not be placed into the routing table unless the previously entered static route to the 192.168.
What is administrative distance in routing?
Administrative distance (AD) or route preference is a number of arbitrary unit assigned to dynamic routes, static routes and directly-connected routes. The value is used in routers to rank routes from most preferred (low AD value) to least preferred (high AD value).
What is directly connected static route?
A directly attached, or directly connected static route, uses the exit interface to forward traffic to the intended destination. This is in contrast to the recursive static route which used the next hop IP address of the router along the path to the destination.
Which routing protocol has the most trustworthy administrative distance by default?
OSPF
By default, OSPF has a default administrative distance of 110 and RIP has a default administrative distance of 120.
What does administrative distance mean?
Administrative distance refers to the trustworthiness of a particular route. A router first installs routes with higher administrative distances. Routes with the smallest metric to a destination indicate the best path.
What is admin distance and metric?
In other words, the administrative distance is used to compare routes originating from different routing protocols (including static and connected), whereas the metric is used to compare routes within one single source of origin or family. …
What is static routing in CCNA?
Static routes are manually added to a routing table through direct configuration. Using a static route, a router can learn about a route to a remote network that is not directly attached to one of its interfaces. The router with the next-hop IP address must be on a directly connected network.
Which routing protocol has the least trustworthy administrative distance by default?
By default, OSPF has a default administrative distance of 110 and RIP has a default administrative distance of 120.
Is the default administrative distance of RIP?
The default administrative distance of RIP is 120.
What is static route in networking?
Static routing is a form of routing that occurs when a router uses a manually-configured routing entry, rather than information from dynamic routing traffic. Unlike dynamic routing, static routes are fixed and do not change if the network is changed or reconfigured.
How to configure administrative distance?
If you are using GNS3 than load the Free CCNA Workbook GNS3 topology than start devices; R1,R2 and R3.
What is IP static route?
NETWORKTYPE — Type either eth0 for ethernet or wlan0 for wireless.
How to configure static routes and default routes?
Configuring a Default Route is as simple as configuring a static route. A default route is represented by 0.0.0.0/0. If you take a second and analyze the network and subnet you’ll realize that any ip address can fall in this subnet from 0.0.0.0 to 255.255.255.255. In this lab you will use the same topology that you’re worked with in the
What is a static route in Cisco?
– Select any application such as SSH from the drop-down. – In the “destination IP address” field, set an IP address that does not belong to available networks. – In the “source IP address” field, fill the IP address of the PC. – In the “Starting source port” field, set any number from the range 1000 to 4000.