How do I know what model EZ UP I have?

How do I know what model EZ UP I have?

Model numbers are placed on a sticker and located on inside of one shelter leg near the upper end.

How is EZ Up measured?

1. Place the end of a measuring tape on the outer edge of one canopy leg and measure to the adjacent leg, noting the length.
2. Measure the second leg to the third.
3. Many square replacement canopies come in basic stock sizes of 8-by-8 feet, 10-by-10 feet and 12-by-12 feet.

How do you waterproof an EZ Up canopy?

How to Make Canopy Waterproof?

1. Clean your canopy.
2. Apply seam sealer and let it set.
3. Use a sponge to scrape off any previously applied waterproof coating that has started to wear off or peel.
4. Spray your whole tent with waterproof spray.
5. Let dry completely.

How do you measure an EZ Up canopy?

The first measurement is the canopy width from inside leg to inside leg. The second measurement is the canopy length from inside leg to inside leg. The third measurement is the length of one side of the roof rafter.

How do I stop my canopy from leaking?

On days when rain is in the forecast, some craft artists put a sheet of clear plastic between the frame of the tent and the fabric canopy in order to prevent leaks. A clear drop cloth is inexpensive, and would do the job.

Can you machine wash an E-Z UP canopy?

Do not use a washing machine to clean your E-Z UP® products. Use a mild soap (not detergent) and plenty of water to clean your E-Z UP® top. Frame will operate and look better if occasionally treated with silicone spray, especially before and after use in damp conditions.

How do I program the EZ-screen®LS safety light screen?

EZ-SCREEN®LS Safety Light Screen www.bannerengineering.com – Tel: +1.763.544.3164 47 Action Indication Comments 2 Turn the programming key switch to the Program position (clockwise) momentarily (> 0.25 second) and then return to the Run position.

How do I program my Eza-rbk-1 led?

EZA-RBK-1 LED: rapid flashing, and then OFF Receiver: Power-up Test Sequence, scan code (“C” and “1” or “2”), and then “C” “H” “1” (repeats) All LEDs turn on momentarily during the Power-up Display Test Sequence. 5 Place the programming key switch in the Program position (clockwise).

How do I connect the earth ground to the EZ-screen LS?

Following relevant electrical standards and wiring codes, such as the NEC, NFPA79 or IEC60204-1, always connect the earth ground (green/yellow wire). Do not operate the EZ-SCREEN LS without an earth ground connection. Make the electrical connections in the order described in this section.

What are the OSHA documents listed on the EZ-screen?

OSHA Documents listed are part of: Code of Federal Regulations Title 29, Parts 1900 to 1910 OSHA 29 CFR 1910.212 General Requirements for (Guarding of) All Machines OSHA 29 CFR 1910.147 The Control of Hazardous Energy (lockout/tagout) OSHA 29 CFR 1910.217 (Guarding of) Mechanical Power Presses EZ-SCREEN®LS Safety Light Screen