How does a Delta bathtub drain work?

Attached to the bottom of the linkage is a cylindrical-shaped drain stopper. When the trip lever is engaged, the tub fills with water because the stopper has closed off the drain pipe. It is for this reason that a broken stopper will cause the tub to slowly lose water.

Are tub drains universal?

Bathtub drains are 1 1/2 inches wide and fit all standard bathtubs ranging from 14 to 26 inches deep. They are this size because they must fit the opening of the P-trap — also 1 1/2 inches wide — which is a special pipe that has a sharp bend in it.

How do you close a pop up tub drain?

Lift-and-Turn Drain Stopper Like the push-and-pull drain stopper, the lift-and-turn stopper is equipped with a small knob at the top. To open, turn it clockwise and pull up a bit on the knob. To close, turn it counterclockwise and push down.

Should bathtub lever be up or down?

With the trip lever down, the plunger is lifted and the drain is open; when the trip lever is up, the plunger is forced down and the drain is closed. And if the tub is accidentally overfilled, excess water can still run down the overflow tube behind the trip-lever plate and can drain away because the plunger is hollow.

Are all tub drains in the same spot?

The position of the tub drain will vary, depending on the size and design of the tub, and you’ll need to cut an access hole in the floor at the drain end of the tub to allow for positioning and installing the drain line.

What is the standard tub drain size?

1 1/2 inches
Down the Drain According to Bonnets Stems and Accessories, Inc., a standard modern bathtub drain is 1 1/2 inches in diameter – the width straight across the middle. Rough-in plumbing should be calculated for a 1 1/2-inch pipe.

How to remove drain stopper from tub Delta?

Wrench or pliers – Depending on how tightly the nut is fastened,you may need a wrench or pliers to loosen it.

Flashlight – A regular hand-held flashlight may be useful because otherwise,you might not be able to see what you are doing beneath the sink.

Brush (e.g.

How to change a Delta tub?

Actuate the pop-up drain’s trip lever to lift the stopper out of the drain pipe.

Remove the screws that secure the cover plate assembly to the bathtub’s wall,using the screwdriver.

Pull the cover plate assembly out of the tub.

Pull the pin securing the stopper to the end of the linkage out of the stopper with pliers.

How to repair a leaking Delta tub spout?

Remove the Set Screw Look for the set screw underneath the spout,close to the wall.

Slide Spout Away From Wall Slide the spout away from the wall gently when you’ve completely removed the screw from the spout.

Remove Old Caulk and Plumber’s Tape Remove old caulk and plumber’s tape before reinstalling the spout.

How to install a Delta bathtub spout?

Allen wrench

Plumber’s tape

Cloth

Pipe wrench