How do I disable passlock?

How do I disable passlock?

Thankfully this is an easy fix.

1. Leave the ignition key turned to the “On” position after the vehicle has stalled and will not start.
2. Look at the dashboard and locate the theft system light.
3. Turn the ignition to the “Off” position to disable the PassLock system, and wait for 20 seconds for the system to reset.

What triggers passlock?

Passlock uses a coded lock cylinder that essentially stops the engine from running until the proper key is detected. When the key is inserted into the ignition, a magnet on the cylinder creates a signal to the ECM (engine control module) that essentially says everything is ok to start and run.

Does passlock disable fuel pump?

Yes, the fuel pump should still run even if there is a passlock issue.

How do I turn off Theftlock on my GM radio?

To disable the Theftlock feature, enter the user or factory back-up code as follows:

1. Write down the user or factory back-up code.
2. Turn the ignition to ACCESSORY or RUN.
3. Turn the radio OFF.
4. Press the 1 and 4 buttons together.
5. Press the Minute button and “000” will appear on the display.

How do you remove an ignition lock cylinder without a Saturn key?

Take your screwdriver and insert it into the ignition lock cylinder. Turn it as far round in a clockwise direction that you can. Then pull the paperclip to the right as much as you can. You should then be able to slide the switch out easily.

How do I bypass service theft deterrent?

To turn off the anti-theft system, use your remote to press the unlock button key. It is advised to use the key to unlock the door and turn on the ignition switch. If that does not work, try to lock the door on the driver’s side using the key while you are out of the car.

How long does it take for PassLock to reset?

This will take approximately 10 to 15 minutes. Start the car immediately once the “Theft Sys” light stays on steadily. Remember to not turn the key off. Your car will now reset the passlock system and start as usual.

What does it mean when your security light comes on?

Hello. On your particular vehicle the security light staying on as the vehicle is running is an indication that the security system has failed and is disabled. It is common for a security light to come on after battery dies because the computer may lose its programming to the key.

What is a PassLock ignition lock system?

Aug 1st, 2005 The PassLock system was designed to prevent vehicle theft by disabling fuel to the engine if attempts are made to start the vehicle without the correct bitted key. PASSLock increased the level of security while retaining the ease of service and costs offered by standard ignition lock systems.

What does a PassLock module do?

PASSLOCK MODULES HAVE MANY NAMES INCLUDING ANTI-THEFT MODULE, VATS MODULE, AND PASSLOCK, BUT THEY ALL REFER TO THE SAME PART. THIS COMPONENT’S JOB IS TO TELL THE ELECTRONIC ENGINE CONTROL MODULE (ECM) THAT THE CORRECT KEY IS BEING USED TO START THE VEHICLE.

What is the difference between Passkey and PassLock?

PASSLock increased the level of security while retaining the ease of service and costs offered by standard ignition lock systems. Unlike the General Motors PASSKey I/II, VATS, PASSKey III, or keyless, the security of the PassLock system is built into the lock and is not dependent on a specialized key or separate device.

Does PassLock stop thefts with no keys?

[1] Well, Passlock should be called the Great Immobilizer because not only does it stop thieves with no keys, it also stops owners with the right keys. GM introduced many security systems – VATS, Passkey, Passlock, but if your GM has a key without a chip in it, chances are it’s passlock.